wood bottom mag. question

G.T. · 09-25-2004, 12:02 AM

Hi Ed! after you press the new button into the follower, you have to set the checkerd face of the button on a piece of aluminum, and re-rivet the pin end using a small, (I believe #2) Stanley nail set... it is accessed thru the small hole on the off slot side! don't get to agressive, or you'll bend the follower button, but one smart rap should do the trick! Good luck! til...lat'r...GT

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

09-25-2004, 12:02 AM	#10
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,540 Thanks: 1,342 Thanked 3,735 Times in 1,019 Posts	Hi Ed! after you press the new button into the follower, you have to set the checkerd face of the button on a piece of aluminum, and re-rivet the pin end using a small, (I believe #2) Stanley nail set... it is accessed thru the small hole on the off slot side! don't get to agressive, or you'll bend the follower button, but one smart rap should do the trick! Good luck! til...lat'r...GT