Sleeve Insertion

Jack Owens · 07-30-2002, 05:13 PM

Dear Fiends,

For those who may be following the sleeve-insertion job that I gave to the Gun Rack, I got a phone-call today from the Gun Rack and was asked if I wanted a .30 caliber bore or 9mm. Since I had already shot 9mm Luger in the pistol, I was a bit disconerted by the question, but I told them that I wanted a 9mm bore.

I asked them if they had considered registering on the Links & Resources section of our Forum, but I was told that they didn't need any more business and had cut down their advertising because they had about as much business as they could handle as a result of satisfied customers. Apparently that was the hold-up on completing the job on my pistol.

I'm to send them a check for $100 and they'll return the barrel to me with the job done.

Stay tuned for the next report.

Regards,
Jack Owens

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-30-2002, 05:13 PM	#22
Jack Owens User Join Date: Jun 2002 Location: Porterville, California Posts: 27 Thanks: 0 Thanked 0 Times in 0 Posts	Dear Fiends, For those who may be following the sleeve-insertion job that I gave to the Gun Rack, I got a phone-call today from the Gun Rack and was asked if I wanted a .30 caliber bore or 9mm. Since I had already shot 9mm Luger in the pistol, I was a bit disconerted by the question, but I told them that I wanted a 9mm bore. I asked them if they had considered registering on the Links & Resources section of our Forum, but I was told that they didn't need any more business and had cut down their advertising because they had about as much business as they could handle as a result of satisfied customers. Apparently that was the hold-up on completing the job on my pistol. I'm to send them a check for $100 and they'll return the barrel to me with the job done. Stay tuned for the next report. Regards, Jack Owens