Take Down Tool Hole <img BORDER="0" src='http://boards.rennlist.com/luger/pic.gif'>

Johnny Peppers · 04-23-2001, 10:24 PM

Probably 95% of the Lugers out there show screwdriver marks on the takedown lever and frame from attempts to unlatch the lever without knowing the correct procedure. I have seen some bent down at 45 degree angles, probably after takeing the advice "get a bigger hammer". These holes could have also been the misguided attempts to look inside to see what had that darned lever locked into postition.

04-23-2001, 10:24 PM	#17
Johnny Peppers User Join Date: Jun 2002 Location: Calion, Arkansas Posts: 1,042 Thanks: 0 Thanked 1 Time in 1 Post	Re: Take Down Tool Hole Probably 95% of the Lugers out there show screwdriver marks on the takedown lever and frame from attempts to unlatch the lever without knowing the correct procedure. I have seen some bent down at 45 degree angles, probably after takeing the advice "get a bigger hammer". These holes could have also been the misguided attempts to look inside to see what had that darned lever locked into postition.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode