Interarms Mauser P-08 Parabellum

Ron Wood · 09-30-2002, 01:36 PM

Runningiron,
I do not think original P08 grips will work on the new Mauser frame. The contour of the originals by the grip screw is curved while on the Mauser the cut is straight. The curve on the heel of the grip could be sanded straight, but the curve on the toe of the grip does not have enough wood to extend far enough down in staight line to make a full Mauser grip. Part of the frame would be exposed. I do not have a new Mauser to verify this observation, so I could be wrong.

09-30-2002, 01:36 PM	#14
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,051 Thanks: 1,121 Thanked 5,287 Times in 1,728 Posts	Runningiron, I do not think original P08 grips will work on the new Mauser frame. The contour of the originals by the grip screw is curved while on the Mauser the cut is straight. The curve on the heel of the grip could be sanded straight, but the curve on the toe of the grip does not have enough wood to extend far enough down in staight line to make a full Mauser grip. Part of the frame would be exposed. I do not have a new Mauser to verify this observation, so I could be wrong. __________________ If it's made after 1918...it's a reproduction

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode