Luger grips

velodog455~ · 08-26-2024, 10:01 AM

G.T.:
I just acquired a 1916 Erfurt with grip numbers that match the last 2 digits of the serial number. The grips are fine in all respects EXCEPT they have shrunk over time and are a loose fit, so much so that the grips pivot fore and aft a tiny bit around the grip screw even when the grip screw has bottomed on the frame.

You didn't mention Erfurts in your above post. I was just wondering if you had any opinions or comments on them.

The Erfurt is a shooter grade so I might try and fit those cheap repro grips I commented on in post #2. Just curious if you had any Erfurt ideas.
-Bob

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-26-2024, 10:01 AM	#11
velodog455~ User Join Date: Aug 2023 Posts: 100 Thanks: 28 Thanked 90 Times in 52 Posts	G.T.: I just acquired a 1916 Erfurt with grip numbers that match the last 2 digits of the serial number. The grips are fine in all respects EXCEPT they have shrunk over time and are a loose fit, so much so that the grips pivot fore and aft a tiny bit around the grip screw even when the grip screw has bottomed on the frame. You didn't mention Erfurts in your above post. I was just wondering if you had any opinions or comments on them. The Erfurt is a shooter grade so I might try and fit those cheap repro grips I commented on in post #2. Just curious if you had any Erfurt ideas. -Bob