P.08 safety adj. 101

G.T. · 12-16-2021, 01:27 PM

Hi Ed, you can actually bend (ever so slightly) the top part of the safety lever, (probably in a soft jaw vice) and get the correct tension you desire? Sometimes, a replacement lever is required if it seems non-compatible with the frame?.. (too loose in the pivot) A custom retaining pin might also help tighten up the lever. Then go to step two, it could be, again, billy goat stiff just from being in or out too far at the lever/bar juncture?.. Best, til....lat'r....GT

12-16-2021, 01:27 PM	#3
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,528 Thanks: 1,334 Thanked 3,711 Times in 1,014 Posts	Sloppy safety? Hi Ed, you can actually bend (ever so slightly) the top part of the safety lever, (probably in a soft jaw vice) and get the correct tension you desire? Sometimes, a replacement lever is required if it seems non-compatible with the frame?.. (too loose in the pivot) A custom retaining pin might also help tighten up the lever. Then go to step two, it could be, again, billy goat stiff just from being in or out too far at the lever/bar juncture?.. Best, til....lat'r....GT

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode