1937 Luger firing issues

4 Scale · 11-28-2020, 09:31 AM

I have encountered the stuck disconnector issue mentioned above. Some people have freed them up with some combination of heat and lubricant. Heat guns can be had cheaply.

They can also be removed and cleaned, but be careful.http://forum.lugerforum.com/showthread.php?t=36571

The issue can also be caused by lack of/incorrect bevel on the transfer lever where it contacts the pin, typically when an aftermarket side plate or transfer lever is new.

If the seller claimed the pistol was functional, you might contact them about fixing it.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

11-28-2020, 09:31 AM	#11
4 Scale User Join Date: Nov 2014 Posts: 544 Thanks: 194 Thanked 490 Times in 251 Posts	I have encountered the stuck disconnector issue mentioned above. Some people have freed them up with some combination of heat and lubricant. Heat guns can be had cheaply. They can also be removed and cleaned, but be careful.http://forum.lugerforum.com/showthread.php?t=36571 The issue can also be caused by lack of/incorrect bevel on the transfer lever where it contacts the pin, typically when an aftermarket side plate or transfer lever is new. If the seller claimed the pistol was functional, you might contact them about fixing it.