Barrel appears to be walking out?

Heinz · 07-22-2020, 11:47 AM

GT, inquiring minds want to Know :-)
Looks to me from the barrel in the block that they turned down a barrel and stuck it into a P08 breach section they reamed out. Then somehow stuck the turned down barrel into the Luger breech. Probably low temp make-believe silver solder. How is my guess

G.T. · 07-22-2020, 11:55 AM

Good morning Heinz, I believe you are spot on with your assessment as to the order of events? But, I think it was/is, just low temp soft solder use in holding the barrel to the tenon... The little pin, as it turns out, did nothing.. although it may have been for indexing if it was installed with a light hand?... best to all, til...lat'r....GT

G.T. · 07-24-2020, 03:09 PM

Well, all continues to go well? First range test had no serious issues, But, it occasionally left an empty in the chamber, maybe 1 out of 6? So, I had to the replace the extractor spring? After that, on the second range test, two magazines full, and a few more.. no problems, snappy ejection, all is well! Now, in the mail and back to Alex...

... Best to all, til....lat'r.....GT

07-22-2020, 11:55 AM	#2
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,541 Thanks: 1,342 Thanked 3,743 Times in 1,020 Posts	exactly! Good morning Heinz, I believe you are spot on with your assessment as to the order of events? But, I think it was/is, just low temp soft solder use in holding the barrel to the tenon... The little pin, as it turns out, did nothing.. although it may have been for indexing if it was installed with a light hand?... best to all, til...lat'r....GT

07-24-2020, 03:09 PM	#3
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,541 Thanks: 1,342 Thanked 3,743 Times in 1,020 Posts	Range test results Well, all continues to go well? First range test had no serious issues, But, it occasionally left an empty in the chamber, maybe 1 out of 6? So, I had to the replace the extractor spring? After that, on the second range test, two magazines full, and a few more.. no problems, snappy ejection, all is well! Now, in the mail and back to Alex... ... Best to all, til....lat'r.....GT

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

07-22-2020, 11:47 AM	#1
Heinz User Join Date: Jun 2002 Location: Greenville SC Posts: 1,004 Thanks: 377 Thanked 411 Times in 180 Posts	GT, inquiring minds want to Know :-) Looks to me from the barrel in the block that they turned down a barrel and stuck it into a P08 breach section they reamed out. Then somehow stuck the turned down barrel into the Luger breech. Probably low temp make-believe silver solder. How is my guess