Barrel appears to be walking out?

G.T. · 07-21-2020, 08:29 PM

Hi hayhugh, the barrel just pulled out leaving the threads with a .500" hole... So, in went the EZ out.... Turned it a little, and boom, all good! Best to you, til....lat'r....GT

G.T. · 07-22-2020, 04:08 AM

Hi Marc, no glue, just the loose solder? But, for not having a barrel flange, the threads were still pretty tight...

.... best, GT

07-21-2020, 08:29 PM	#1
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,541 Thanks: 1,342 Thanked 3,743 Times in 1,020 Posts	didn't have to cut Hi hayhugh, the barrel just pulled out leaving the threads with a .500" hole... So, in went the EZ out.... Turned it a little, and boom, all good! Best to you, til....lat'r....GT

07-22-2020, 04:08 AM	#2
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,541 Thanks: 1,342 Thanked 3,743 Times in 1,020 Posts	no glue!!!! Hi Marc, no glue, just the loose solder? But, for not having a barrel flange, the threads were still pretty tight... .... best, GT

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode