Surface prep question?

G.T. · 08-30-2019, 01:57 PM

Hi to all, Chemicals would be nice, even with all the problems and precautions...but, I can't use liquids as I only need to address certain areas in the interior of each part, (can't tolerate drips and runs!) .... Masking and blasting seem to be the most promising, and maybe I can reduce masking time as I go along...

..... I am open to all ideas and suggestions... best to all, til….lat'r.....GT....

08-30-2019, 01:57 PM	#13
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,541 Thanks: 1,342 Thanked 3,743 Times in 1,020 Posts	Chemicals and issues Hi to all, Chemicals would be nice, even with all the problems and precautions...but, I can't use liquids as I only need to address certain areas in the interior of each part, (can't tolerate drips and runs!) .... Masking and blasting seem to be the most promising, and maybe I can reduce masking time as I go along... ..... I am open to all ideas and suggestions... best to all, til….lat'r.....GT....

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode