Round not consistently extracting

4 Scale · 10-05-2018, 10:40 PM

What ammo are you using? Did you replace the extractor spring? A picture of the extractor tip might help as well.

On your toggle not locking back, you might try a different mag. Mec Gars are the recommended aftermarket brand. Sometimes on some pistols a stronger mag spring can improve hold open function; forum member GT has installed those for me in the past. That you replaced the mainspring and now it's not holding open may indicate the mainspring is a bit too strong, not uncommon if you are using 115gr. target ammo. IMO when replacing mainsprings or when the HO function is not always working, a tape test should be done (search the forums and you'll find how to do it).

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

10-05-2018, 10:40 PM	#1
4 Scale User Join Date: Nov 2014 Posts: 544 Thanks: 194 Thanked 490 Times in 251 Posts	What ammo are you using? Did you replace the extractor spring? A picture of the extractor tip might help as well. On your toggle not locking back, you might try a different mag. Mec Gars are the recommended aftermarket brand. Sometimes on some pistols a stronger mag spring can improve hold open function; forum member GT has installed those for me in the past. That you replaced the mainspring and now it's not holding open may indicate the mainspring is a bit too strong, not uncommon if you are using 115gr. target ammo. IMO when replacing mainsprings or when the HO function is not always working, a tape test should be done (search the forums and you'll find how to do it).