1940 restoration

4 Scale · 08-27-2017, 07:36 PM

For pins that are a bit tight, I have used a drill press. Starter punches probably work better than the press on really tight pins. The small pin in the toggle knob has a dimple on top due to the manufacturing process - it is not a roll pin. It presses out from the bottom.

The small toggle knob pin and the s-link pin are the most difficult pins in the Luger pistol to remove, at least for me.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-27-2017, 07:36 PM	#10
4 Scale User Join Date: Nov 2014 Posts: 544 Thanks: 194 Thanked 490 Times in 251 Posts	For pins that are a bit tight, I have used a drill press. Starter punches probably work better than the press on really tight pins. The small pin in the toggle knob has a dimple on top due to the manufacturing process - it is not a roll pin. It presses out from the bottom. The small toggle knob pin and the s-link pin are the most difficult pins in the Luger pistol to remove, at least for me.