First Luger, (1916 DWM) question on origin (mismatched parts)

Thor · 06-15-2017, 01:04 PM

IF you shoot it much you might change out the firing pin from a WWI pin (non fluted) to a fluted one that tends to prevent damage to the breech block at the firing pin retainer notch in the event of pressure coming back into the breech from a pierced primer or overload. Luger Doc (his screen name here) has them and the switch over takes about a minute or two with only a small screw driver (many can do it with just your thumb) to take out the retainer, then the spring and pin follow. WWII pins are FLUTED and help a bunch. NICE shooting by the way.

06-15-2017, 01:04 PM	#6
Thor User Join Date: Jun 2002 Location: Rio Rancho, New Mexico Posts: 4,583 Thanks: 958 Thanked 971 Times in 277 Posts	IF you shoot it much you might change out the firing pin from a WWI pin (non fluted) to a fluted one that tends to prevent damage to the breech block at the firing pin retainer notch in the event of pressure coming back into the breech from a pierced primer or overload. Luger Doc (his screen name here) has them and the switch over takes about a minute or two with only a small screw driver (many can do it with just your thumb) to take out the retainer, then the spring and pin follow. WWII pins are FLUTED and help a bunch. NICE shooting by the way. __________________ Thor's Luger Clinic http://members.rennlist.com/lugerman/ Ted Green (Thor Yaller Boots) 725 Western Hills Dr SE, Rio Rancho, NM 87124 915-526-8925 Email thor340@aol.com ----------------------------------- John3:3 Jesus answered and said to him, "Most assuredly, I say to you, unless one is born again, he cannot see the kingdom of God."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode