"Pinned" Interarms Mauser Grips ???

alvin · 05-21-2017, 08:53 PM

It's a weird change. I did not see how this could save much production cost. Putting this pin there also took effort. They used cast steel, that could save cost in pre-CNC era.

DonVoigt · 05-21-2017, 09:21 PM

Quote:

Originally Posted by alvin

It's a weird change. I did not see how this could save much production cost. Putting this pin there also took effort. They used cast steel, that could save cost in pre-CNC era.

That's cause you don't make "stuff"; the work/cost savings is in the interior grip shaping that was eliminated, and overall simplification of the grip and its fitting to the frame

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

05-21-2017, 08:53 PM	#1
alvin User Join Date: Jul 2007 Location: US Posts: 3,843 Thanks: 132 Thanked 729 Times in 438 Posts	It's a weird change. I did not see how this could save much production cost. Putting this pin there also took effort. They used cast steel, that could save cost in pre-CNC era.