New acquisition 1900AE

JVH · 03-08-2017, 01:29 AM

Thank you. I found a replacement extractor at the Sarco web site. It doesn't appear to need a spring or pin. It has pin that appears to go into a hole in the front of the toggle and a round protrusion that fits into the top of the bolt. I assume it is held in place by tension and probably was prone to breakage, hence the change to later design, pinned to the bolt with a spring under it at the rear. I'll research the toggle lock issue.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

03-08-2017, 01:29 AM	#6
JVH User Join Date: Mar 2017 Posts: 21 Thanks: 0 Thanked 19 Times in 10 Posts	Thank you. I found a replacement extractor at the Sarco web site. It doesn't appear to need a spring or pin. It has pin that appears to go into a hole in the front of the toggle and a round protrusion that fits into the top of the bolt. I assume it is held in place by tension and probably was prone to breakage, hence the change to later design, pinned to the bolt with a spring under it at the rear. I'll research the toggle lock issue.