G.T. Snail drum arrived - what does it fit?

spacecoast · 02-10-2017, 11:02 AM

Don -

Thanks a lot, I apologize for not paying better attention and going back to review once I had the drum in hand. To get the follower to stay in place last night prior to installing the loader I finally figured out that it was easier to hand load the first couple of rounds.

To take the drum apart (after winding), which center screw do I remove? The one on the winder side, or the one on the back side, or both?

02-10-2017, 11:02 AM	#8
spacecoast User Join Date: Dec 2013 Location: FL and PA Posts: 332 Thanks: 276 Thanked 243 Times in 109 Posts	Don - Thanks a lot, I apologize for not paying better attention and going back to review once I had the drum in hand. To get the follower to stay in place last night prior to installing the loader I finally figured out that it was easier to hand load the first couple of rounds. To take the drum apart (after winding), which center screw do I remove? The one on the winder side, or the one on the back side, or both? __________________ My avatars are the Bulgarian word for "Fire", as seen on my 1900, 1906 and 1908 Bulgarian Contract DWM Lugers. Looking for a DWM Commercial side plate #95

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode