Sear plunger pin and S-link pin removal

[Olle]

Originally Posted by 4 Scale

The table is sturdier than the drill press. The drill press is a modest Delta. All force was applied with one hand to the press arm while seated, so I'd call the force to push the pins out "significant" but not "great".

I'm talking about the adjustable table on the drill press. Mine will flex a bit if I press hard enough, so it can probably snap off the column if I press hard enough. I'm just waiting for one of those really old floor models to show up for sale, they are extremely solid and would be perfect for this purpose. They are fairly inexpensive, and you can get one for next to nothing if it doesn't work.

Originally Posted by DonVoigt

Good show!
Most important part is if those pins don't need attention- leave them alone!

Either area can be lubed using a "needle" oiler.
The sear plunger can be freed up or lubed by soaking in some penetrating oil for an hour or 10!

And where's the sport in that?