1939 Mauser Banner E/F

Edward Tinker · 07-07-2016, 12:28 AM

REWROTE - Well, the Simson side plate would be incorrect FOR MOST BANNERS. A lucky match by number, but those parts should have been out of the system by that time. I imagine someone could say that the side plate and sear were replaced at that time...

Isn't the safety lever BAR a #13? OR WHAT IS IT?

Would depend on how much it went for?

I think its likely to be considered a high end shooter? Perhaps more, but there are issues?

It's a police, Mauser toggle, so I think value is tough. Perhaps $1200

07-07-2016, 12:28 AM	#2
Edward Tinker Super Moderator Eternal Lifer LugerForum Patron Join Date: Jun 2002 Location: North of Spokane, WA Posts: 15,976 Thanks: 2,074 Thanked 4,609 Times in 2,123 Posts	REWROTE - Well, the Simson side plate would be incorrect FOR MOST BANNERS. A lucky match by number, but those parts should have been out of the system by that time. I imagine someone could say that the side plate and sear were replaced at that time... Isn't the safety lever BAR a #13? OR WHAT IS IT? Would depend on how much it went for? I think its likely to be considered a high end shooter? Perhaps more, but there are issues? It's a police, Mauser toggle, so I think value is tough. Perhaps $1200 __________________ Edward Tinker ************ Co-Author of Police Lugers - Co-Author of Simson Lugers Author of Veteran Bring Backs Vol I, Vol II, Vol III and Vol IV Last edited by Edward Tinker; 07-07-2016 at 03:42 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode