Locking Bolt issues

Elapid · 02-21-2016, 01:28 AM

OK Here's where I am, I have part of the spring about 1/4" sticking straight out of the Hole it goes into. trying to push it up broke most of it with the rest sticking straight out of the hole. I't been soaking in oil all day. Do you think heat might loosen it up to where I could get it out? What should I use to pull it out? Worse case scenario would be to have it break off flush with the frame where I'd have to drill it out, that might be tricky.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-21-2016, 01:28 AM	#17
Elapid User Join Date: Apr 2014 Location: MS Posts: 24 Thanks: 3 Thanked 0 Times in 0 Posts	OK Here's where I am, I have part of the spring about 1/4" sticking straight out of the Hole it goes into. trying to push it up broke most of it with the rest sticking straight out of the hole. I't been soaking in oil all day. Do you think heat might loosen it up to where I could get it out? What should I use to pull it out? Worse case scenario would be to have it break off flush with the frame where I'd have to drill it out, that might be tricky.