Custom G date Carbine

lugerholsterrepair · 02-12-2016, 12:15 AM

Jack, Eric, They are the screws in the brass oval of the forearm..On Ed's carbine they are brass and look bad..I am trying to find out their size..Now I need the diameter of the flat head and the length..the diameter of the shaft would be nice too..These screws will not be threaded all the way but will have a short blanc shaft. They must be a good steel and fire blued...All of which I could get IF I knew the size!
I would easily get this off of my own carbine but it is a thousand miles away...

02-12-2016, 12:15 AM	#34
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,134 Times in 1,439 Posts	Jack, Eric, They are the screws in the brass oval of the forearm..On Ed's carbine they are brass and look bad..I am trying to find out their size..Now I need the diameter of the flat head and the length..the diameter of the shaft would be nice too..These screws will not be threaded all the way but will have a short blanc shaft. They must be a good steel and fire blued...All of which I could get IF I knew the size! I would easily get this off of my own carbine but it is a thousand miles away... __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode