Parts from Lugerman!

lugerholsterrepair · 01-10-2016, 10:52 PM

GT..Proud of you my Man! I hate to appear stupid. I haven't any more rivets for "fxo" magazine bottoms . By rivets are you meaning "pins" that hold on the mag pull bottoms? Cornfused...Or are there some rivets I am unaware of?

G.T. · 01-10-2016, 11:08 PM

Hi Jer, yes! the "fxo" "code 122" thru center retaining pin / rivet, is the same whether it is on an aluminum or Bakelite bottom, It is a soft steel 3MM / .118" dia. X .800" long, and when squeezed between the two rivet sets, it expands the ends slightly, thus permanently holding the bottom on the tube?... Lot's of them have been pounded out and it's pretty tough on the magazine as a result? (Almost 100% breakage on the black Bakelite bottoms if not predrilled?) I try to make several hundred at a time, but man is it boring!!!!!!!

.... I haven't had much in extra time, so I will have to pass the ball to Lugerdoc, who generally keeps a good supply of my stuff on hand.... When he wants more, I'll probably make them then?

... best to all, til....lat'r....GT....

01-10-2016, 10:52 PM	#1
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,134 Times in 1,439 Posts	GT..Proud of you my Man! I hate to appear stupid. I haven't any more rivets for "fxo" magazine bottoms . By rivets are you meaning "pins" that hold on the mag pull bottoms? Cornfused...Or are there some rivets I am unaware of? __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know." Last edited by lugerholsterrepair; 01-10-2016 at 11:39 PM.

01-10-2016, 11:08 PM	#2
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,541 Thanks: 1,342 Thanked 3,743 Times in 1,020 Posts	fxo stuff! Hi Jer, yes! the "fxo" "code 122" thru center retaining pin / rivet, is the same whether it is on an aluminum or Bakelite bottom, It is a soft steel 3MM / .118" dia. X .800" long, and when squeezed between the two rivet sets, it expands the ends slightly, thus permanently holding the bottom on the tube?... Lot's of them have been pounded out and it's pretty tough on the magazine as a result? (Almost 100% breakage on the black Bakelite bottoms if not predrilled?) I try to make several hundred at a time, but man is it boring!!!!!!! .... I haven't had much in extra time, so I will have to pass the ball to Lugerdoc, who generally keeps a good supply of my stuff on hand.... When he wants more, I'll probably make them then? ... best to all, til....lat'r....GT....

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode