Advice Needed

Castle · 11-18-2015, 02:38 PM

First, thanks for all the helpful posts. Much appreciated. Have now tried the masking tape test, and, although it's a little hard to tell, I think the stop on the rear toggle link is hitting the frame where it needs to. Yes, I can load one round in the mag., chamber it, and it fires and locks back as it should. I have examined the ramps and found no sign of rough toolmarks, even under light magnification. I have not polished the chamber, but I have made sure it's clean. The ammo I have used is as follows: Fiocchi 93 grs. SJSP; Fiocchi 93 grs. FMJ; PPU 93 grs. FMJ; Winchester 93 gr. FMJ. Thanks again to all.......CF

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

11-18-2015, 02:38 PM	#1
Castle User Join Date: Jan 2008 Location: New England Posts: 25 Thanks: 0 Thanked 7 Times in 5 Posts	First, thanks for all the helpful posts. Much appreciated. Have now tried the masking tape test, and, although it's a little hard to tell, I think the stop on the rear toggle link is hitting the frame where it needs to. Yes, I can load one round in the mag., chamber it, and it fires and locks back as it should. I have examined the ramps and found no sign of rough toolmarks, even under light magnification. I have not polished the chamber, but I have made sure it's clean. The ammo I have used is as follows: Fiocchi 93 grs. SJSP; Fiocchi 93 grs. FMJ; PPU 93 grs. FMJ; Winchester 93 gr. FMJ. Thanks again to all.......CF