Breech block extractor problem

Vic103 · 08-22-2015, 10:14 PM

You are right, moving my barrel one revolution would require approximately.050 of stock removal. (I just checked it.) So that is not an option. Yes I have had extractor out and no the extractor is not broken.

I made a brass plug exactly.776 in length slightly smaller than the diameter of the chamber. The toggle with breechblock will close and lock on it. You can feel it touch the chamber lip edge and breechblock face. It hardly takes any force at all to lock the toggle, but it won't close in a free state.

I was shooting Federal 9mm Luger ammo.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-22-2015, 10:14 PM	#11
Vic103 User Join Date: Aug 2012 Posts: 28 Thanks: 0 Thanked 7 Times in 5 Posts	You are right, moving my barrel one revolution would require approximately.050 of stock removal. (I just checked it.) So that is not an option. Yes I have had extractor out and no the extractor is not broken. I made a brass plug exactly.776 in length slightly smaller than the diameter of the chamber. The toggle with breechblock will close and lock on it. You can feel it touch the chamber lip edge and breechblock face. It hardly takes any force at all to lock the toggle, but it won't close in a free state. I was shooting Federal 9mm Luger ammo.