LugerForum Discussion Forums my profile | register | faq | search
upload photo | donate | calendar

Go Back   LugerForum Discussion Forums > General Discussion Forums > Repairs, Restoration & Refinishing

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 08-10-2015, 02:29 PM   #20
DonVoigt
User
 
DonVoigt's Avatar
 
Join Date: Apr 2015
Location: near Charlotte NC
Posts: 4,681
Thanks: 1,443
Thanked 4,355 Times in 2,041 Posts
Default

It would very hard for the toggle to fail if locked, it would be under compression, all the force being transfered straight back to the toggle axle and thus the fork.

The fork broke at the sharp cut where the opening transition is, a weak spot due to the "corner" present.

If the fork was over hard, or brittle to begin with; then use over the years could cause cracks radiating from each corner, and a final failure- perhaps even with standard ammo.

We don't know enough about this to call it an ammo problem just yet, likely a contributor- yes; for certain = unknown without more info. JMHO.
DonVoigt is offline   Reply With Quote
The following 3 members says Thank You to DonVoigt for your post:
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -4. The time now is 11:48 PM.


Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 1998 - 2025, Lugerforum.com