1942 Luger (Issue #2)

rhuff · 08-04-2015, 04:10 PM

Another place to look is the breechface. Be sure that there is no buildup of crud(scientific term) where the casehead fits into the breechface. I had a buildup in that area that caused a problem. It doesn't take a lot to be problematic. Remove the firing pin and spring, then place a cartridge into the breechface and see if the extractor is holding it firmly in place.....it should if everything is correct.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

08-04-2015, 04:10 PM	#12
rhuff Patron LugerForum Patron Join Date: Mar 2011 Location: Az. Posts: 2,315 Thanks: 2,750 Thanked 999 Times in 734 Posts	Another place to look is the breechface. Be sure that there is no buildup of crud(scientific term) where the casehead fits into the breechface. I had a buildup in that area that caused a problem. It doesn't take a lot to be problematic. Remove the firing pin and spring, then place a cartridge into the breechface and see if the extractor is holding it firmly in place.....it should if everything is correct.