Erma .22 conversion for P 08; FIRING update post #21

[hayhugh]

You may find it necessary to remove the ejector on the receiver that you are using.

[DonVoigt]

Originally Posted by hayhugh

You may find it necessary to remove the ejector on the receiver that you are using.

You are correct, the barrel is impossible to insert without removal
of the original ejector.

[DonVoigt]

Originally Posted by sheepherder

Do you have all the parts??? I seem to recall a 'centering cone' going between the nut and the muzzle...Your pic looks like it is missing (lots of thread showing)...

This is a pic of the commercial kit...I don't recall if the 'centering cone' was threaded as well as the retaining nut...

There is a parts breakdown of the wartime kit posted here somewhere too, but this was the one I knew I could find...

Yes, I have all the parts, well except one muzzle nut,
that is why more thread is showing, supposed to have two as shown in your post.

The centering busing is part of the barrel extension that goes between the barrel and the nuts. You can see it as the brass bushing on the extension in my picture.

The length of my barrel is longer than the commercial one, hence a longer extension.

The original kit is in Vol. III of Sturgess.