My first Borchardt,

Ron Wood · 11-26-2004, 08:56 PM

Murray,
You did great! I had forgotten about the raised machining around the trigger guard, so make that 3 significant changes! The difference in the side plate is one of the changes I was looking for. The other change I was looking for is perhaps the most significant and probably can't be seen in a side view.

I am not sure about the pin in the recoil spring housing (I don't have a DWM Borchardt either), but I believe the slot in the sear bar exists on both models.

11-26-2004, 08:56 PM	#11
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,040 Thanks: 1,106 Thanked 5,257 Times in 1,724 Posts	Murray, You did great! I had forgotten about the raised machining around the trigger guard, so make that 3 significant changes! The difference in the side plate is one of the changes I was looking for. The other change I was looking for is perhaps the most significant and probably can't be seen in a side view. I am not sure about the pin in the recoil spring housing (I don't have a DWM Borchardt either), but I believe the slot in the sear bar exists on both models. __________________ If it's made after 1918...it's a reproduction

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode