Getting these to funtion

rhuff · 03-31-2015, 05:25 PM

One thing that I always consider on the 7.65Para(30 luger) is the shoulder on the brass. Be sure that your sizing die is fully down and that it is setting the shoulder back far enough. I was having a problem with this, and removed .015-.020in. off of the base of the sizing die(via lathe) to remedy the problem. Compare your handloads to factory new 7.65 ammo as to where they sit in the chamber(with the toggle train removed). Hold the barrel vertical and drop the ammo into the chamber. Just a thought.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

03-31-2015, 05:25 PM	#1
rhuff Patron LugerForum Patron Join Date: Mar 2011 Location: Az. Posts: 2,308 Thanks: 2,737 Thanked 993 Times in 729 Posts	One thing that I always consider on the 7.65Para(30 luger) is the shoulder on the brass. Be sure that your sizing die is fully down and that it is setting the shoulder back far enough. I was having a problem with this, and removed .015-.020in. off of the base of the sizing die(via lathe) to remedy the problem. Compare your handloads to factory new 7.65 ammo as to where they sit in the chamber(with the toggle train removed). Hold the barrel vertical and drop the ammo into the chamber. Just a thought.