Please help ID this Luger

alanint · 03-21-2015, 08:10 AM

The chances of leaving a mark are low. The extractor pin will almost always come out with simple hand pressure. Make sure to hold the extractor down with your thumb to make it easier. The pin area cannot be seen when the pistol is assembled, anyhow.

SoftwarePerson · 03-22-2015, 01:11 PM

Quote:

Originally Posted by alanint

The chances of leaving a mark are low. The extractor pin will almost always come out with simple hand pressure. Make sure to hold the extractor down with your thumb to make it easier. The pin area cannot be seen when the pistol is assembled, anyhow.

How easy or hard is it to remove and replace the safety bar?

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

03-21-2015, 08:10 AM	#1
alanint User Join Date: Mar 2008 Location: Marco Island, Florida Posts: 4,867 Thanks: 1,685 Thanked 1,917 Times in 1,193 Posts	The chances of leaving a mark are low. The extractor pin will almost always come out with simple hand pressure. Make sure to hold the extractor down with your thumb to make it easier. The pin area cannot be seen when the pistol is assembled, anyhow.