DWM Commerical breechblock question

sheepherder · 02-23-2015, 09:55 AM

That's a head-scratcher for sure...If it had been dented OUT, I'd say excessive dry-firing...But dented IN, WTF???

I looked at the breechblock print, the cross section, and that area around the firing pin hole is the thinnest part of the breechface, but I really can't see anything that could dent it in...

The only thing that comes to mind is maybe it was dented out from dry firing and some-bubba hammered it back in...Too far...

If that was true, I would expect the firing pin to not protrude as much as it should...

Great problem! Thanks for bringing it up!

02-23-2015, 09:55 AM	#1
sheepherder Lifer Lifetime Forum Patron Join Date: Feb 2009 Location: ...on the 'ol Erie Canal... Posts: 8,208 Thanks: 1,425 Thanked 4,474 Times in 2,343 Posts	That's a head-scratcher for sure...If it had been dented OUT, I'd say excessive dry-firing...But dented IN, WTF??? I looked at the breechblock print, the cross section, and that area around the firing pin hole is the thinnest part of the breechface, but I really can't see anything that could dent it in... The only thing that comes to mind is maybe it was dented out from dry firing and some-bubba hammered it back in...Too far... If that was true, I would expect the firing pin to not protrude as much as it should... Great problem! Thanks for bringing it up! __________________ I like my coffee the way I like my women... ...Cold and bitter...

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode