Long Barrel .22 Conversion

[sheepherder]

Originally Posted by Diver6106

Note that the toggle pin that came out should have a locking pin that goes down a small hole thru the toggle, near finger grips, into a detent on the left side of the pin. This is like the locking pin on the safety or take down lever. Georg seemed to like this pin method to lock parts in.

Originally Posted by Edward Tinker

Can you provide a picture of what you are saying, because I can't picture it.

Ed - I couldn't either; your toggle wasn't drilled for an axle pin retaining pin IIRC - and my pic in post #10 above don't show a hole for one either...

...But the Gun Digest parts schematic in the other thread DOES show one...WTF???