Loose Safety

Bill Sipple · 02-03-2015, 01:45 PM

One more slightly related question: after cleaning, my mag release button will not stay in place. I have the small curved spring installed correctly, with the tiny dimple inserted into the frame slot, but it seems about a mm too short to engage the button and the frame at the same time. Again, it could be that it was so gunked up originally that maybe that's what kept it in place. Or, could I have chipped off a mm of this spring at either end ? It will definitely either engage the frame, or the button, but not both (almost not both).

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

02-03-2015, 01:45 PM	#12
Bill Sipple User Join Date: Jan 2015 Posts: 11 Thanks: 0 Thanked 0 Times in 0 Posts	One more slightly related question: after cleaning, my mag release button will not stay in place. I have the small curved spring installed correctly, with the tiny dimple inserted into the frame slot, but it seems about a mm too short to engage the button and the frame at the same time. Again, it could be that it was so gunked up originally that maybe that's what kept it in place. Or, could I have chipped off a mm of this spring at either end ? It will definitely either engage the frame, or the button, but not both (almost not both).