Threaded Barrel Luger DWM 1911 - Need Help

DavidJayUden · 10-16-2014, 12:08 PM

But a blank adapter would let most of the pressure out, using just enough to push the toggle back. So a lot of threads would not be necessary.
Does the mainspring seem as strong as other Lugers or does this one cycle easier?
Any supressor that I have ever seen would be way too much load on those threads due to length and weight, and that combined with the thin-ness required of the tubing walls, to me, at least, makes a supressor application unlikely.
The MAC10 and 11 uses maybe a half inch of very deep and course threads, and they feel very adequate.
I still vote "blank adapter", but in truth it was probably the mindless and purposeless work of a couple of youngsters in dad's shop many years ago.
dju

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

10-16-2014, 12:08 PM	#17
DavidJayUden Patron LugerForum Patron Join Date: Nov 2008 Posts: 4,047 Thanks: 578 Thanked 1,414 Times in 887 Posts	But a blank adapter would let most of the pressure out, using just enough to push the toggle back. So a lot of threads would not be necessary. Does the mainspring seem as strong as other Lugers or does this one cycle easier? Any supressor that I have ever seen would be way too much load on those threads due to length and weight, and that combined with the thin-ness required of the tubing walls, to me, at least, makes a supressor application unlikely. The MAC10 and 11 uses maybe a half inch of very deep and course threads, and they feel very adequate. I still vote "blank adapter", but in truth it was probably the mindless and purposeless work of a couple of youngsters in dad's shop many years ago. dju