Finnish Board Stock

[Dick Herman]

Here it is Jussi,

Seems to be a regular artillery slab stock with Finnish markings. As you can see the 1954 and Y mark are in the groove for the lug connection device. Any idea what the T represents below the SA on the slab side?

[jussi16]

Hello.

T=Talousvarikko. You could translate it as "the Maintenance Depot".

[sheepherder]

Originally Posted by Dick Herman

Seems to be a regular artillery slab stock with Finnish markings.

Dick -

Inasmuch as you have removed the attaching iron, are you sure it is for the Luger and not the Lahti??? The gripframe lugs are similar but the lock/cutout location is different...

[Dick Herman]

Richard,
I have never examined a Lahti stock or attachment device. However, your question forced me to play with my stuff. The pictured upside down stock attachment is identical to my other artillery rigs and accepted the Artillery Lugers that were inserted. This is a Luger Artillery stock.

[jussi16]

There were only some prototype and test shoulder stocks for the Lahti. To find a genuine is really hard.
Most moving around are repros. And even they are rare.

[sheepherder]

Originally Posted by jussi16

There were only some prototype and test shoulder stocks for the Lahti. To find a genuine is really hard.
Most moving around are repros. And even they are rare.

Jussi -

The stock-holster you have shown is very cool; but I was hoping that Dick had a Lahti board stock that he had no use for...So I could buy it from him and use it with an altered Luger artillery holster for my 'artillery Lahti'...

Making a curved attachment iron is outside my skill zone right now; I'm having a hard enough time making a straight one...

[John Sabato]

Originally Posted by sheepherder

...Making a curved attachment iron is outside my skill zone right now; I'm having a hard enough time making a straight one...

Rich, you can do this... think it through.

My suggestion would be either a rotary table cutting the inside curve,... or to do it on the cheap, put the raw attachment iron in a good vise and use a specially ground tool in a fly cutter in your vertical mill that is set up for the appropriate cut radius... Then walk the tool into the iron SLOWLY...

[sheepherder]

Originally Posted by John Sabato

My suggestion would be either a rotary table cutting the inside curve...

I have thought of that; using a small keyway cutter...But a Luger attching iron would be simpler and quicker...

Here's a pic of the two gripframes...I don't have my verniers handy (I'm taking a motherboard to the PO) but except for the locking notch, the curve looks quite close...

I've seen pics of Lugers with attached board stocks that were at a Gawd-awful angle; I'm guessing that the stock was a Finnish board stock, locked at the Luger notch...Lugers & Lahtis are the only gripframes with external "T" lugs...

I have a Mauser stock iron that I'm using as a design aid, but I really need to find a Luger repro stock iron...