ejecter re install side plate assembly

alanint · 07-21-2014, 08:22 AM

The rear of the ejector needs to be gently lifted in order to clear a small seating/locking protrusion on the frame.

The problem with the gun not resetting the firing pin is most likely related to the plunger at the end of the sear bar. make sure there is no debris around the sear and that the plunger moves freely. I have buffed the side of the plunger that faces farthest outward to make sure it both clears and resets the firing pin.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

07-21-2014, 08:22 AM	#3
alanint User Join Date: Mar 2008 Location: Marco Island, Florida Posts: 4,867 Thanks: 1,685 Thanked 1,917 Times in 1,193 Posts	The rear of the ejector needs to be gently lifted in order to clear a small seating/locking protrusion on the frame. The problem with the gun not resetting the firing pin is most likely related to the plunger at the end of the sear bar. make sure there is no debris around the sear and that the plunger moves freely. I have buffed the side of the plunger that faces farthest outward to make sure it both clears and resets the firing pin.