Luger S/42 1937 with PSE marked barrel

DavidJayUden · 05-12-2014, 05:38 PM

I have no idea what P S E stands for, but it is definitely not the original barrel. If you remove the upper from the lower receiver, there should be a tiny line connecting the upper barrel extension to the barrel on the very bottom. We call it a witness mark and it shows original factory alignment, and I suspect that will not be correct either.
Also, I can't tell from the photos if the trigger, takedown lever and safety lever are all straw colored or blue, and also we need the full serial number and the letter following the number.
Thanks, and welcome aboard.
dju

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

05-12-2014, 05:38 PM	#2
DavidJayUden Patron LugerForum Patron Join Date: Nov 2008 Posts: 4,047 Thanks: 578 Thanked 1,414 Times in 887 Posts	I have no idea what P S E stands for, but it is definitely not the original barrel. If you remove the upper from the lower receiver, there should be a tiny line connecting the upper barrel extension to the barrel on the very bottom. We call it a witness mark and it shows original factory alignment, and I suspect that will not be correct either. Also, I can't tell from the photos if the trigger, takedown lever and safety lever are all straw colored or blue, and also we need the full serial number and the letter following the number. Thanks, and welcome aboard. dju