Barrel replacement services update!

G.T. · 04-28-2014, 02:54 PM

Hi Rich and all! Sorry, just got back to this thread! And, I'm afraid I'm in the same boat as the rest of you, when it comes to silver solder???... I've not done enough to trust my limited experience... The machining wouldn't be too tough??... But, then again, I've not yet attempted it... Best to all, til...lat'r....GT BTW, Rich, I'll certainly help you out in any way I can!! ...

04-28-2014, 02:54 PM	#19
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,530 Thanks: 1,334 Thanked 3,711 Times in 1,014 Posts	Late to the party! Hi Rich and all! Sorry, just got back to this thread! And, I'm afraid I'm in the same boat as the rest of you, when it comes to silver solder???... I've not done enough to trust my limited experience... The machining wouldn't be too tough??... But, then again, I've not yet attempted it... Best to all, til...lat'r....GT BTW, Rich, I'll certainly help you out in any way I can!! ...

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode