![]() |
my profile |
register |
faq |
search upload photo | donate | calendar |
|
![]() |
#1 |
Lifer
Lifetime Forum Patron Join Date: Dec 2003
Location: PORT ST LUCIE, FLORIDA
Posts: 12,216
Thanks: 6,209
Thanked 4,138 Times in 2,176 Posts
|
![]()
Definitely~~~
|
![]() |
![]() |
![]() |
#2 |
Patron
LugerForum Patron Join Date: Mar 2011
Location: Az.
Posts: 2,308
Thanks: 2,737
Thanked 993 Times in 729 Posts
|
![]()
I purchased one of the cheap replica/aftermarket loading tools, and it "sort of worked". It kept slipping off of the mag button. When I checked it out, I found that the back side that goes against the mag, was no where near flat. I resurfaced the back side by rubbing it over a piece of emery paper(approx 220 grit) that was on a piece of flat glass.
This technique squared up the back surface of the tool, and now it works like a dream. Like Marc, I only load 5 rounds in a mag, or a cylinder when I am at the range. That gives me a 5 shot group. |
![]() |
![]() |
![]() |
Thread Tools | |
Display Modes | |
|
|