COLT single action Army revolver, advice needed.

Ron Wood · 03-17-2014, 06:55 PM

The best Colt clone I have handled and also own is one that was assembled, factory tuned and finshed by AWA (American Western Arms) from parts obtained from Pietta in Italy. It has a crisp trigger pull and fantastic timing...I have cycled the action easily over a hundred times and there is still no "drag mark" on the cylinder. The gun was such an exact copy that Colt sued AWA and won so the guns are no longer produced...really too bad. If a similar gun could be obtained in Italy from Pietta I think it would be a great choice.

03-17-2014, 06:55 PM	#14
Ron Wood Moderator 2010 LugerForum Patron Join Date: Jun 2002 Location: Santa Teresa New Mexico just outside of the West Texas town of El Paso Posts: 7,040 Thanks: 1,106 Thanked 5,257 Times in 1,724 Posts	The best Colt clone I have handled and also own is one that was assembled, factory tuned and finshed by AWA (American Western Arms) from parts obtained from Pietta in Italy. It has a crisp trigger pull and fantastic timing...I have cycled the action easily over a hundred times and there is still no "drag mark" on the cylinder. The gun was such an exact copy that Colt sued AWA and won so the guns are no longer produced...really too bad. If a similar gun could be obtained in Italy from Pietta I think it would be a great choice. Attached Thumbnails __________________ If it's made after 1918...it's a reproduction

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode