An 'Artillery' Nambu and Lahti

sheepherder · 03-06-2014, 06:47 PM

Chambering has been outlined in two previous threads -

Artillery Barrel Specs

http://forum.lugerforum.com/showthread.php?t=21048

and -

Alternative Artillery Barrel Fabrication

http://forum.lugerforum.com/showthread.php?t=25858

- So I won't repeat the steps here. Stripped bolt is used to set headspace and breech gap. Barrel is then removed and the middle is rough turned. The barrel is also milled flat on all four sides where the rear sight base will be, and then is set back in the lathe to turn off the front sight base section.

(The battery in my digi-cam crapped out while the milling operations were going on; my apologies).

03-06-2014, 06:47 PM	#4
sheepherder Lifer Lifetime Forum Patron Join Date: Feb 2009 Location: ...on the 'ol Erie Canal... Posts: 8,198 Thanks: 1,416 Thanked 4,462 Times in 2,336 Posts	Chambering has been outlined in two previous threads - Artillery Barrel Specs http://forum.lugerforum.com/showthread.php?t=21048 and - Alternative Artillery Barrel Fabrication http://forum.lugerforum.com/showthread.php?t=25858 - So I won't repeat the steps here. Stripped bolt is used to set headspace and breech gap. Barrel is then removed and the middle is rough turned. The barrel is also milled flat on all four sides where the rear sight base will be, and then is set back in the lathe to turn off the front sight base section. (The battery in my digi-cam crapped out while the milling operations were going on; my apologies). Attached Thumbnails __________________ I like my coffee the way I like my women... ...Cold and bitter... Last edited by sheepherder; 03-06-2014 at 09:09 PM.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode