Does anyone turn (machine) Luger barrels?

lfid · 10-18-2013, 04:55 AM

Garrett,
I have a barrel that may work ok for you
I purchased it some time ago from another luger forum member

I think it was from someones abandoned carbine project and is at least 12" probably 9mm and P08 (short receiver) threaded with extractor notch cut

but does not have the carbine rear sight or sight mount collar, so is like a heavier standard profile luger barrel similiar to some of the 12" post ww1 commercial lugers
it is in the white unblued and no front sight

forum member GT offers barrel mounting and fitting services and would be an excellent way to for you resolve the fitting etc work

in any case you should have someone with needed skills do the barrel install

will look for it now in storage somewhere if you are interested

in any case good luck with your project
thanks !!!
Bill

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

10-18-2013, 04:55 AM	#1
lfid Lifer Lifetime Forum Patron Join Date: Sep 2006 Location: Wichita, KS USA Posts: 453 Thanks: 573 Thanked 96 Times in 53 Posts	Garrett, I have a barrel that may work ok for you I purchased it some time ago from another luger forum member I think it was from someones abandoned carbine project and is at least 12" probably 9mm and P08 (short receiver) threaded with extractor notch cut but does not have the carbine rear sight or sight mount collar, so is like a heavier standard profile luger barrel similiar to some of the 12" post ww1 commercial lugers it is in the white unblued and no front sight forum member GT offers barrel mounting and fitting services and would be an excellent way to for you resolve the fitting etc work in any case you should have someone with needed skills do the barrel install will look for it now in storage somewhere if you are interested in any case good luck with your project thanks !!! Bill