FTF & Stove Piping issues...

mrerick · 09-02-2013, 12:23 PM

The Luger is very sensitive to how you grip and support the gun while firing.

It needs a relatively strong consistent support in order to cycle properly.

I don't think you can Lubricate a Luger into a FTF problem. There are some things to take a look at. One is how hard the toggle rear is hitting the receiver when firing. Put a little masking tape right at the back of the receiver under the place where the toggle will hit it. Take a look at how consistent this is hitting, and how hard.

After verifying that the magazines are OK, you might need a replacement recoil spring.

These later Mauser Lugers use the higher count (21 turn) recoil springs.

Marc

09-02-2013, 12:23 PM	#5
mrerick Super Moderator - Patron LugerForum Life Patron Join Date: Dec 2009 Location: Eastern North Carolina, USA Posts: 3,925 Thanks: 1,377 Thanked 3,140 Times in 1,520 Posts	The Luger is very sensitive to how you grip and support the gun while firing. It needs a relatively strong consistent support in order to cycle properly. I don't think you can Lubricate a Luger into a FTF problem. There are some things to take a look at. One is how hard the toggle rear is hitting the receiver when firing. Put a little masking tape right at the back of the receiver under the place where the toggle will hit it. Take a look at how consistent this is hitting, and how hard. After verifying that the magazines are OK, you might need a replacement recoil spring. These later Mauser Lugers use the higher count (21 turn) recoil springs. Marc __________________ Igitur si vis pacem, para bellum - - Therefore if you want peace, prepare for war.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode