Question Regarding Imperial Rod

Neil Young · 06-25-2013, 04:27 PM

..I would guess it would be a tad difficult to accurately make one of these grease barrel rods?

I think you are absolutely right Jerry--it would really be difficult.

Jerry, I can do pretty good on some small, tedious projects, but I am not a really good craftsman. There are people on this forum who are, in my estimation, Master Craftsmen. The two that I can think of offhand are Olle and Postino. I know that there are others that I am forgetting, or just don't know about. Check out some of their work--it's awesome!

06-25-2013, 04:27 PM	#13
Neil Young Lifer Lifetime Forum Patron Join Date: Jun 2008 Location: Scottsboro, Alabama Posts: 552 Thanks: 567 Thanked 449 Times in 170 Posts	..I would guess it would be a tad difficult to accurately make one of these grease barrel rods? I think you are absolutely right Jerry--it would really be difficult. Jerry, I can do pretty good on some small, tedious projects, but I am not a really good craftsman. There are people on this forum who are, in my estimation, Master Craftsmen. The two that I can think of offhand are Olle and Postino. I know that there are others that I am forgetting, or just don't know about. Check out some of their work--it's awesome! __________________ Neil The hurrier I go the behinder I get. Sometimes it takes me all day to get nothing done. Last edited by Neil Young; 06-25-2013 at 04:51 PM. Reason: added more text

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode