Navy Toggle Train

G.T. · 06-11-2013, 01:30 PM

That little slanted arm on the left hand side, is just an extension from the pin that goes thru to hold the coupling link, (part that goes down into the recoil pivot arm, bellcrank??)... drive that pin out from right to left... Push in the button, and the sight slider will come of the toggle...

..best to you, til...lat'r...GT

Olle · 06-11-2013, 03:59 PM

Aha, I thought there was a way to wiggle it out. Ok, I'll pound it out then.

G.T. · 06-11-2013, 04:28 PM

support the toggle well, have a flat face perfect dia. punch... and tap straight.... it should really push out... but you aren't going to find a replacement...

...proceed with extreme caution.... best of luck to you Olle, til...lat'r....GT

sheepherder · 06-11-2013, 05:21 PM

Quote:

Originally Posted by Olle

Aha, I thought there was a way to wiggle it out. Ok, I'll pound it out then.

There is no problem that a BMFH won't solve!...

Olle · 06-11-2013, 05:49 PM

"Use the force, Luke..."

G.T. · 06-11-2013, 07:31 PM

Lordy, lordy, lordy!! I've seen that before!

...good luck! til...lat'r.....GT

06-11-2013, 01:30 PM	#1
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,529 Thanks: 1,334 Thanked 3,711 Times in 1,014 Posts	hi Olle That little slanted arm on the left hand side, is just an extension from the pin that goes thru to hold the coupling link, (part that goes down into the recoil pivot arm, bellcrank??)... drive that pin out from right to left... Push in the button, and the sight slider will come of the toggle... ..best to you, til...lat'r...GT

06-11-2013, 04:28 PM	#3
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,529 Thanks: 1,334 Thanked 3,711 Times in 1,014 Posts	super careful!!! support the toggle well, have a flat face perfect dia. punch... and tap straight.... it should really push out... but you aren't going to find a replacement... ...proceed with extreme caution.... best of luck to you Olle, til...lat'r....GT

06-11-2013, 07:31 PM	#6
G.T. Lifer Lifetime Forum Patron Join Date: Jun 2002 Location: Chandler Arizona Posts: 3,529 Thanks: 1,334 Thanked 3,711 Times in 1,014 Posts	Oh Oh.... Lordy, lordy, lordy!! I've seen that before! ...good luck! til...lat'r.....GT

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

06-11-2013, 03:59 PM	#2
Olle User Join Date: Feb 2010 Location: Tennessee Posts: 1,149 Thanks: 159 Thanked 664 Times in 318 Posts	Aha, I thought there was a way to wiggle it out. Ok, I'll pound it out then.

06-11-2013, 05:49 PM	#5
Olle User Join Date: Feb 2010 Location: Tennessee Posts: 1,149 Thanks: 159 Thanked 664 Times in 318 Posts	"Use the force, Luke..."