Luger snubnose project - Page 2

oldphardt · 02-02-2014, 05:35 PM

Good idea.

Olle · 02-03-2014, 09:29 AM

I guess I should also have mentioned that it's way easier to set up the block at an angle, rather than tilting the column or setting the index table at an angle. I used angle blocks to set it at the correct angle, so the setup for this cut was very quick and easy.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

02-02-2014, 05:35 PM	#1
oldphardt User Join Date: Sep 2013 Posts: 12 Thanks: 0 Thanked 1 Time in 1 Post	Good idea.

02-03-2014, 09:29 AM	#2
Olle User Join Date: Feb 2010 Location: Tennessee Posts: 1,149 Thanks: 159 Thanked 664 Times in 318 Posts	I guess I should also have mentioned that it's way easier to set up the block at an angle, rather than tilting the column or setting the index table at an angle. I used angle blocks to set it at the correct angle, so the setup for this cut was very quick and easy.