ID Frame Only??

03-31-2002, 12:34 AM

Most parts will not be machined on a single machine,

But will have certain operations machined in secquence on several separate machines before hand finishing and inspection.

This much further complicates the question of obtaining a consistent finish on all parts unless carefully applied by a skilled craftsman like OUR "THOR", This is not to say that there are other good ones, But! He is the best I'm aquainted with.

ViggoG

03-31-2002, 12:34 AM	#6
Viggo G Dereng Guest Posts: n/a	Re: Incidentally Most parts will not be machined on a single machine, But will have certain operations machined in secquence on several separate machines before hand finishing and inspection. This much further complicates the question of obtaining a consistent finish on all parts unless carefully applied by a skilled craftsman like OUR "THOR", This is not to say that there are other good ones, But! He is the best I'm aquainted with. ViggoG

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode