Magazine Issue?

lugerholsterrepair · 03-16-2013, 06:24 PM

mags still stick out of the bottom slightly..This more common than not on Lugers and is not a real indicator of anything IMO.

Have you looked at the underside of the bolt? At the bolt stop slot? This should be sharp and in good condition. Remember the bolt will stay back only if both the holdopen and this slot mate up well..

Have you shot the pistol and it will not stay open? Or are you just operating it by hand?

Did you actually take out the holdopen and spring? Or just inspect it in place?

03-16-2013, 06:24 PM	#5
lugerholsterrepair Moderator Lifetime Forum Patron Join Date: Jun 2002 Location: Arizona/Colorado Posts: 7,775 Thanks: 4,995 Thanked 3,134 Times in 1,439 Posts	mags still stick out of the bottom slightly..This more common than not on Lugers and is not a real indicator of anything IMO. Have you looked at the underside of the bolt? At the bolt stop slot? This should be sharp and in good condition. Remember the bolt will stay back only if both the holdopen and this slot mate up well.. Have you shot the pistol and it will not stay open? Or are you just operating it by hand? Did you actually take out the holdopen and spring? Or just inspect it in place? __________________ Jerry Burney 11491 S. Guadalupe Drive Yuma AZ 85367-6182 lugerholsterrepair@earthlink.net 928 342-7583 (CO & AZ) Year Round 719 207-3331 (cell) "For those who Fight For It, Life has a flavor the protected will never know."

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode