Police Holster

Edward Tinker · 02-16-2013, 03:28 PM

yes and then no

yes, Jerry Burney can fix the lid

No, you can not and should not attempt to remove the markings on the rear, you'd have to rub them off, then instead of markings, you'd have a deep rubbing or gouge.

Pretty sure It started life as an artillery holster (see stitching markings on back) - but there should be markings on the outside or stamped on the inside of the lid.

What markings are on the tool?
.
Show pictures of complete holster, front and rear, show close ups of markings please.

02-16-2013, 03:28 PM	#2
Edward Tinker Super Moderator Eternal Lifer LugerForum Patron Join Date: Jun 2002 Location: North of Spokane, WA Posts: 15,974 Thanks: 2,072 Thanked 4,609 Times in 2,123 Posts	yes and then no yes, Jerry Burney can fix the lid No, you can not and should not attempt to remove the markings on the rear, you'd have to rub them off, then instead of markings, you'd have a deep rubbing or gouge. Pretty sure It started life as an artillery holster (see stitching markings on back) - but there should be markings on the outside or stamped on the inside of the lid. What markings are on the tool? . Show pictures of complete holster, front and rear, show close ups of markings please. __________________ Edward Tinker ************ Co-Author of Police Lugers - Co-Author of Simson Lugers Author of Veteran Bring Backs Vol I, Vol II, Vol III and Vol IV

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode