Trying to id my P08

rhuff · 10-09-2012, 05:04 PM

I also am a reloader. I believe that you will find that minimum powder loads in 9mm will not cycle the toggle. Of course, a lot depends on what mainspring your Luger has installed. I might suggest starting at mid level of powder, then go 0.1gr both up and down, to see which way works the best. Most Luger reloaders strive for a load that is accurate, and the least powder and still have it function 100%. Good luck.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

10-09-2012, 05:04 PM	#1
rhuff Patron LugerForum Patron Join Date: Mar 2011 Location: Az. Posts: 2,314 Thanks: 2,746 Thanked 998 Times in 733 Posts	I also am a reloader. I believe that you will find that minimum powder loads in 9mm will not cycle the toggle. Of course, a lot depends on what mainspring your Luger has installed. I might suggest starting at mid level of powder, then go 0.1gr both up and down, to see which way works the best. Most Luger reloaders strive for a load that is accurate, and the least powder and still have it function 100%. Good luck.