Repair cost.

Lugerdoc · 09-08-2012, 11:45 AM

I do have PO8 disconnector plungers @$10, spring & pin @$5 each + $5 S&H. Sometimes if the old spring has collasped and the plunger is stuck inside, they are VERY difficult or impossible to get out. Just make sure that they are missing and not stuck. TH PS: while you have the trigger bar removed, also check that the inside where the FP cocks is OK.

mahd776 · 09-08-2012, 10:39 PM

Thanks all for the resposes and advise. I bid what I was comfortable with in light of the needed repair but missed out by $100.00. This pistol was at Rock Island Auction Co's three day auction that started yesterday. My brother and I went to the preview Thursday but I missed looking at this particular pistol. Would have ended up with about $1750.00 in it before the needed repair. To be honest I was concerned about putting that into it and finding that I had to replace a numbered part for the gun to function and it ending up being worth a lot less than I spent. I do like the advise to buy one that is a good looking shooter and a collector later. I also need to research and educate myself on Lugers in general before laying out money! Thanks again!

09-08-2012, 11:45 AM	#1
Lugerdoc Patron LugerForum Patron Join Date: Jun 2002 Location: POB 398 St.Charles,MO. 63302 Posts: 5,089 Thanks: 6 Thanked 737 Times in 484 Posts	I do have PO8 disconnector plungers @$10, spring & pin @$5 each + $5 S&H. Sometimes if the old spring has collasped and the plunger is stuck inside, they are VERY difficult or impossible to get out. Just make sure that they are missing and not stuck. TH PS: while you have the trigger bar removed, also check that the inside where the FP cocks is OK. __________________ Tom Heller POB 398 ST.Charles, MO. 63302 Tel 636-447-3006 lugerdoc@charter.net

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

09-08-2012, 10:39 PM	#2
mahd776 User Join Date: Sep 2012 Posts: 29 Thanks: 2 Thanked 6 Times in 3 Posts	Thanks all for the resposes and advise. I bid what I was comfortable with in light of the needed repair but missed out by $100.00. This pistol was at Rock Island Auction Co's three day auction that started yesterday. My brother and I went to the preview Thursday but I missed looking at this particular pistol. Would have ended up with about $1750.00 in it before the needed repair. To be honest I was concerned about putting that into it and finding that I had to replace a numbered part for the gun to function and it ending up being worth a lot less than I spent. I do like the advise to buy one that is a good looking shooter and a collector later. I also need to research and educate myself on Lugers in general before laying out money! Thanks again!